Interior panel production (Part 2)

these is a continuation of the interior panel production process reported the other day.

To be honest, I think it is hard to convey the content this time,

Wow, what a pain in the ass you are doing,

I hope you can skip over it lightly.

I am trying to express a three-dimensional graffiti,

A 2cm square hole is drilled in the surface of the panel.

Here is the end of the hole (at the back).

I have already put a tear on it first.

these is attached to the hole,

It will look like this.

It’s hard to understand, isn’t it?

Here is a further close-up photo.

A 1 cm square hole is made behind the 2 cm square hole.

I don’t understand.

these is not a photoshopping problem or anything,

It’s hard to tell even when you see the real thing (laughs).

Well, it’s just a matter of self-satisfaction.

Never mind, I will continue to stretch the rips.

Stretch further.

The above is from late April to early May.

The above is a report of our work from late April to early May.

The rest of this report will follow later!